Commit 59418443 authored by Jan Kadlec's avatar Jan Kadlec

Fixes in documentation based on code review.

Refs #37
parent de06a686
......@@ -99,7 +99,7 @@ depends on what you passed to the @code{./configure}, usually @code{/etc}.
$ knotc -c slave.conf checkconf # check configuration
$ knotd -c slave.conf
@end example
Estimate memory consumption for zone start it as a daemon, @code{knotc} tool should be used.
However to start it as a daemon, @code{knotc} tool should be used.
The @code{knotc} tool accepts parameter @code{-w} to wait until the requested operation finishes.
When the action is "start" for example, it waits until the server starts to serve zones.
@example
......@@ -118,7 +118,7 @@ you can use @code{knotc checkzone} action.
$ knotc -c master.conf checkzone example.com
@end example
For an aproximate estimate of server's memory consumption, you can use the @code{knotc memstats} action.
For an approximate estimate of server's memory consumption, you can use the @code{knotc memstats} action.
This action prints count of resource records, percentage of signed records and finally estimation
of memory consumption for each zone, unless specified otherwise. Please note that estimated values might
differ from the actual consumption. Also, for slave servers with incoming transfers enabled,
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment